 |
 |
 |
 |
| Here’s a worn SRAM Force rear mech that I’m currently pondering about. My plan is to figure out how to remove the pivot pins so that I can take the parallelogram pieces apart. Once they are apart I will do a massive shaving job to save some grams. The limit screws are all currently steel and M4 in size, I plan on taping the holes out so they accept M5 Nylon limit screws. After all that, hopefully I can fab a titanium spring and aluminum or titanium pivot bolts to put it all back together. I’m shooting for a 50 gram savings with this project. Next |
Search This Blog
- SRAM Shift Lever Tuning
- SRAM Force RD Tuning
- Isaac Force Build
- Cleaning KCNC Calipers
- Tuning Campy Record FD's
- Addict Built
- Ruegamer Build
- Muriatic acid for broken posts
- Roll Out Dents
- Remove Seized Seatposts
- Remove Seized Stems
- Determine Your Bike Size
- Cranks & Bottom Brackets
- Quill Stem Basics
- Tune Derailers
- Tires and Tubes
- Remove Tight Fitting Tires
- Remove & Install Chains w.o. chain tool
- Cantilever Brakes