| Just got these fresh out of the mill. I added the dowels to see if it’ll keep everything straight and true a bit better. This will be my first attempt at rolling out a dent and I’ve heard mixed opinions about it so I’ll see for myself tomorrow. When I specified the sizes for these i merely looked online for the sizing. Most spec’ed a block with a 1.0 inch diameter (25.4mm). After having these made I actually measured the top tube of the frame and although it varied from section to section the average came out to be around 25.7mm, .3mm BIGGER than what I had made. This might make it a bit interesting. |
 |
 |
Search This Blog
- SRAM Shift Lever Tuning
- SRAM Force RD Tuning
- Isaac Force Build
- Cleaning KCNC Calipers
- Tuning Campy Record FD's
- Addict Built
- Ruegamer Build
- Muriatic acid for broken posts
- Roll Out Dents
- Remove Seized Seatposts
- Remove Seized Stems
- Determine Your Bike Size
- Cranks & Bottom Brackets
- Quill Stem Basics
- Tune Derailers
- Tires and Tubes
- Remove Tight Fitting Tires
- Remove & Install Chains w.o. chain tool
- Cantilever Brakes